·       Supports 200GBASE-LR4

·       Lane bit rate 53.125 Gb/s with PAM4

·       Up to 10km transmission on SMF

·       LAN WDM laser and PIN receiver

·       200GAUI-8 Electrical interface with 8 Lanes 26.5625Gb/s NRZ high-speed signal

·       QSFP-DD MSA package with duplex LC connector

·       Compliant with IEEE 802.3cn 200GBASE-LR4

·       Single +3.3V power supply

·       Maximum power consumption 10W

·       Operating case temperature: 0 to +70 °C

·       Compliant to QSFP-DD CMIS & QSFP-DD MSA HW standard

·       Complies with EU Directive 2015/863/EU

Absolute Maximum Ratings

Recommended Operating Conditions

Optical Characteristics

1.       Average launch power, each lane (min) is informative and not the principal indicator of signal strength. A

          transmitter with launch power below this value cannot be compliant; however, a value above this does not

          ensure compliance.

2.       Even if the TDECQ < 1.4 dB for an extinction ratio of ≥ 4.5 dB or TDECQ < 1.3 dB for an extinction ratio of < 4.5 dB,

          the OMA_outer (min) must exceed this value.

3.       The receiver shall be able to tolerate, without damage, continuous exposure to an optical input signal having this average power level.

4.       Average receive power, each lane (min) is informative and not the principal indicator of signal strength. A received power below this value cannot be compliant; however, a value above this                does not ensure compliance.

5.       Measured with conformance test signal at TP3 for the BER 2.4E-4.

Electrical Characteristics

High-Speed Signal:      Compliant to 200GAUI-8 (IEEE 802.3bs)

Low-Speed Signal:       Compliant to QSFP-DD-Hardware.